Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - togedes

Pages: [1]
1
Technical Help: Problems BEFORE entering the game /
« on: January 31, 2005, 06:33:17 pm »
Thanks for the tip, it was a bad export\" command. Now ldd says that libcal3d is correctly linked.

The game works well now, except i have no sound.
Software mode eats all CPU and i can\'t find a mode where the sound works...

I think a readme or howto should be send inside the linux zip file.

2
Technical Help: Problems BEFORE entering the game /
« on: January 31, 2005, 01:08:43 pm »
Yes, the paths are correctly set.
And i have already updated and all is up to date according to the updater.

The error message in console is :
Failed to load mesh factory from file /planeshift/models/enkim/enkim.cal3d

3
Technical Help: Problems BEFORE entering the game / Linux : "Couln't find mesh" and fails start
« on: January 28, 2005, 08:39:11 pm »
Hello

I installed the linux version and run the updater : the updater say nows it\'s up-to-date.
When i launch the game, i can log in but i have an error message : \"Couldn\'t find mesh ! Please run the updater.\"
The model of my charachter is not displayed...

I have a mandrake 10.2.

Thanks for the tips.

4
Technical Help: Problems BEFORE entering the game / problem with installer
« on: January 28, 2005, 04:34:00 pm »
Impossible to enter the game because there was a problem with meshes.
I had a lot of \"Skipping file art/buttons/xxxxxxxxx.png, because it\'s readonly\"

I do a \"chmod -R +w art\" in order to let the updater work normally.
Now, the updater works fine...

5
Technical Help: Problems BEFORE entering the game /
« on: January 28, 2005, 03:46:20 pm »
It would be a good idea to add this howto to the linux archive, since there is no readme.

Pages: [1]