- Status Closed
- Percent Complete
- Task Type Bug Report
- Category
- Assigned To No-one
- Operating System
- Severity Medium
- Priority
- Reported Version
- Due in Version Undecided
-
Due Date
Undecided
-
Votes
1
- Anonymous Submitter (16.11.2008)
- Private
Attached to Project: PlaneShift
Opened by Anonymous Submitter - 16.11.2008
Last edited by Caarrie - 28.01.2009
Opened by Anonymous Submitter - 16.11.2008
Last edited by Caarrie - 28.01.2009
FS#2472 - pssetup closed by DAC on startup
For some reason Vista thinks that pssetup.exe is a windows process that requires DAC, then DAC decides to promptly close the program. When you try and disable it for pssetup.exe it says that it requires dac =/
Closed by Caarrie
28.01.2009 14:29
Reason for closing:
Additional comments about closing:
28.01.2009 14:29
Reason for closing:
Additional comments about closing:
closing as wont fix as pssetup is being
replaced
Ok its DEP not DAC -.-
<Botanic> Faulting application pssetup.exe, version 0.4.2.0, time stamp 0x48b2ba64, faulting module unknown, version 0.0.0.0, time stamp 0x00000000, exception code 0xc0000005, fault offset 0x5c3a433b, process id 0x640, application start time 0x01c947ed996c1b70.
<Botanic> http://pastebin.com/m4f321992
Couldn't reproduce on Vista.
What is the binary you are using? Release, build one?
Not clear: did you try disabling the DAC or the DEP?
What is your DEP configuration? (look into System > Advanced > Performance Options > Data Execution Prevention)
Release Binary
Turn DEP on for essential Windows programs and services only.
Tried changing it to except those i select and it said
This program must tun with data execution protection DEP enabled. You cannot turn off DEP for this program.
when I tried to disable it
Also it says
Your computers processor supports hardware-based DEP.
When i run
bcdedit.exe /set {current} nx AlwaysOff
setup runs fine
bcdedit.exe /set {current} nx AlwaysOn to turn it back on after
Also if i turn DEP off then back on after it is started the program runs fine
EDIT: now it doesnt crash on startup at all…
Also tried a reboot its running fine now i bet if the setup program does anything only on first run thats the issue, ill try a reinstall